WRD fiber-line cutout system

BOBCAT

Dual spindles you know.
Vacuum that tops itself up.

Two winding spindles, driven by your drill or the included hand crank, the way you already cut out on Orange Bat. Underneath, ePump X monitors vacuum and tops it up, so you never stop mid-cut to re-pump.

Choose your kit See why it’s built this way

Vacuum system: ePump X Monitors and tops up
Spindle drive: 5/16″ hex Takes your Bison drive accessories
Suction pad: 6.5″ VP7 Sized for an electric pump

Where Bobcat comes from

Run an Orange Bat?
You already know Bobcat.

The original Orange Bat
Two spindles. Your control.
Orange Bat set the dual-spindle way WRD technicians cut out glass. Bobcat keeps it.
The later Bison ePump
Vacuum without the pumping.
The ePump brought automatic vacuum to Bison. ePump X builds on it.

What changed

Rebuilt around
the electric pump.

Going electric meant a new pump and a bigger cup.

ePump X

2,000 mAh in a smaller pump.

Two-thirds more rated capacity and a new board, reconfigured around the same motor into a smaller shell. Charges over USB-C.

Rated capacity
1,200 → 2,000 mAh

Explore ePump X
The right cup

A 6-inch cup wasn’t enough.

An electric pump pulls less than a hand pump, and in production a 6-inch cup fell short. The low-profile 6.5-inch VP7, with a refined sealing edge, matches and slightly exceeds Orange Bat and Orange Bat QC.

VP7 pad · +17% nominal area
6.0 → 6.5″
On the glass

Hold to start. No re‑pumping.

Press and hold the button to start, and the pad pulls down with vacuum on the display. ePump X keeps it topped up for the rest of the cut.

Typical, fully engaged
~70 kPa

In your hands

You drive the cut.

Wind one spindle with your drill or the hand crank while the U-bit locks the other. You set the pace; your Bison drive accessories carry straight over.