Manual vacuum install system

PRO6 4-Cup

Four manual-pump cups.
One Long Double Hook set.

Each base handling cup draws its own vacuum with a hand plunger and shows a red-line indicator at the pump. The Long Double Hook set mounts in the cups’ square Quick Connect ports. Supplied with a 17-inch tool tote and the instruction manual.

PRO6 Install System: 17-inch tool tote, half-letter instruction manual, four PRO6 base handling cups and the two members of one Long Double Hook set
Vacuum
Manual plunger Red-line indicator on each cup
Suction pad
6″ WRD VP3 152 mm, side release tab
Mount
Square Quick Connect port Long Double Hook set included
Display layout only, not a placement guide.

Compared with the original PRO6 Install System

A fourth cup.
A longer hook.

The original PRO6 Install System has three base handling cups, the standard Double Hook and the Extended Arm. This kit has four cups and the Long Double Hook set. The Extended Arm is not included.

Base handling cups
3 to 4
Hook slide member
16¼″ to 19″
Original 3-cup PRO6 Install System

PRO6 Base Handling Cup

Manual vacuum.
Red-line indicator.

All four are the same PRO6 base handling cup. Each one is self-contained: its own plunger pump, its own red-line indicator.

01 / Layout

Handle, pump, port, pad.

Handle across the top. Plunger pump at the back. Square Quick Connect port at the front. VP3 suction pad underneath.

02 / Vacuum

Plunger pump and red line.

Draw vacuum by hand with the plunger. The red-line indicator gives a visual vacuum check at the cup. Pumping and checking steps are in the supplied instruction manual.

Pump clip is illustrative: stroke count and plunger travel are not measured.

Base Handling Cup details

VP3 suction pad

6-inch VP3 pad.
Side release tab.

Each cup runs a 6-inch WRD VP3 suction pad with the release tab on its side and a felt filter in the pad’s air hole. Replacement pads are sold separately.

Pad diameter
6″ 152 mm
Replacement VP3 pad

Quick Connect

Square Quick Connect port.

One on the front of every cup. Each Long Double Hook member mounts in a port by its square end.

Mount
Quick Connect PRO
Standard Double Hook slide → Long Double Hook slide. Both are fixed length; the animation compares them.

Long Double Hook

Longer slide.
Same square port.

The Long Double Hook slide member is 19 inches. The standard Double Hook slide is 16¼ inches. Both mount in the square Quick Connect port.

Slide member
16¼″ to 19″
Standard Double Hook → Long Double Hook

Long Double Hook

Slide and base members.
One set.

One Long Double Hook set: a slide member and a base member, each with a square mount end for the Quick Connect port.

The Extended Arm and standard Double Hook are not included in this kit.

Slide
19″
Base
16″

Nominal lengths. Fixed-length members.

Long Double Hook details

The kit

Kit contents.

Ordered as one kit. Single cups and service parts are listed under Service below.

Display layout only, not a cup or hook placement guide. Tote and manual are shown in the top image.

Follow the supplied instruction manual for setup and use.

Service

Pads, pumps, single cups.

Replacement pads, pumps, other cup parts, single cups and the tote are each sold separately.